Barrierta L 55/2

Special lubricating grease for metal pairings in the boundary friction regime
MICROLUBE GNY 202 is a special lubricating grease based on mineral oil. It also contains special sodium soap and the MICROLUBE additive package, which ensures a wear-free surface finish. Running-in wear is reduced to a minimum. In addition, the MICROLUBE additive package provides protection in the boundary friction regime. MICROLUBE GNY 202 shows high resistance to pressure and good anticorrosion properties.

Low-temperature greases for slides and small gears
Kluberlub LM 41-32 N and Kluberlub LM 41-102 are special greases based on mineral oil and a lithium soap thickener. Due to their low base oil viscosity Kluberlub LM 41-32 N and Kluberlub LM 41-102 are suitable for temperatures down to –40°C.

Single-component, air-drying bonded coating for flocked seals
Klubertop TP 18-810 N is an air-drying, water-based bonded coating.

Synthetic air compressor oils for oil change intervals up to 10,000 operating hours
Kluber Summit SH oils are air compressor oils based on synthetic hydrocarbon and additives. They can be mixed with mineral oils and synthetic hydrocarbon oils, however are not miscible with polyglycol oils.

Synthetic low-temperature grease with good damping properties
Klubersynth LI 44-22 is a fully synthetic, dynamically light low-temperature grease with good damping and adhesion properties as well as water resistance. It is based on synthetic hydrocarbons, lithium soap, antifriction solid lubricants as well as corrosion and oxidation inhibitors. Klubersynth LI 44-22 is almost neutral towards many plastics and elastomers.

Water-miscible sliding dispersion for windscreen wipers made of synthetic or natural rubber and other elastomer components
Windscreen wiper blades are subject to extreme and sometimes conflicting requirements. On the one hand wiper blades have to be structurally stable enough to resist mechanical stress during operation, on the other hand they have to have sufficient flexibility to ensure a satisfactory wiping pattern is achieved in contact with the windscreen. Optimum frictional behavior, especially in the dry/wet friction regime, is therefore of vital importance. Kluberplus S 02-004 has been designed especially for optimization of the frictional behavior of wiper blades. A secondary benefit of the lubricant is that assembly of the wiper blades is also much easier. This also applies to the assembly of other components, such as O-rings etc.. Once applied, Kluberplus S 02-004 forms a dry, flexible, sliding film which ensures prevention of stick slip sliding with minimal lubricant transfer to the mating surface, e.g. the windscreen.