Kluberfluid C- PG 17 Ultra

Synthetic air compressor oils for oil change intervals up to 10,000 operating hours
Kluber Summit SH oils are air compressor oils based on synthetic hydrocarbon and additives. They can be mixed with mineral oils and synthetic hydrocarbon oils, however are not miscible with polyglycol oils.

High-temperature and long-term grease for rolling bearings
Kluberplex BEM 41-132 is based on synthetic hydrocarbon oil, mineral oil and a special lithium soap. Special additives ensure optimum oxidation resistance as well as protection against wear and corrosion.

Operational lubricant for large girth gear drives
Kluberfluid C-F 3 Ultra is a lubricant of a new generation, developed specifically for the lubrication of medium-size to large girth gear drives. It is based on synthetic hydrocarbons and mineral oil. It provides good adhesion, excellent resistance to high pressure and protection against wear. This product is suitable for use at component temperatures up to 120°C.
Kluberfluid C-F 3 Ultra meets the requirements of ANSI/AGMA 9005-E02 annex D-2.

Synthetic air compressor oils for oil change intervals up to 8,000 operating hours
Kluber Summit SB oils are air compressor oils based on synthetic hydrocarbons and additives. These oils are miscible with mineral oils and synthetic hydrocarbon oils, but not with oils based on polyglycol.
Kluber Summit SB oils offer excellent oxidation and ageing stability and show a good viscosity-temperature behaviour.

High-temperature screw paste
Kluberpaste HEL 46-450 is a black hot screw paste for high-alloy steels. It contains fully synthetic polyalkylene glycol and ester base oils and a combination of inorganic solid lubricants.
Kluberpaste HEL 46-450 is suitable for a temperature range between -40°C and 1000°C. In the normal temperature range (i.e. below 200°C) it shows good anticorrosion behaviour and good water resistance. Above 200°C it acts as a dry lubricant.

Heavy-duty grease for highly-loaded rolling bearings operating at low speeds
Kluberlub BE 41-1501 is designed to meet the requirements of rolling bearings subject to extreme conditions.
FAG FE 8 tests have confirmed the effectiveness of Kluberlub BE 41-1501 under these conditions and it is approved by various bearing manufacturers, e.g. FAG, to be used for applications in low-speed rolling bearings subject to very high loads and shocks, for example in roller presses and bowl mill crushers.