Kluberfluid B-F 2 Ultra

High-temperature screw paste
Kluberpaste HEL 46-450 is a black hot screw paste for high-alloy steels. It contains fully synthetic polyalkylene glycol and ester base oils and a combination of inorganic solid lubricants.
Kluberpaste HEL 46-450 is suitable for a temperature range between -40°C and 1000°C. In the normal temperature range (i.e. below 200°C) it shows good anticorrosion behaviour and good water resistance. Above 200°C it acts as a dry lubricant.

Synthetic air compressor oils for oil change intervals up to 10,000 operating hours
Kluber Summit SH oils are air compressor oils based on synthetic hydrocarbon and additives. They can be mixed with mineral oils and synthetic hydrocarbon oils, however are not miscible with polyglycol oils.

Operational lubricant for large gear drives
Klubersynth OA 98-15000 is based on the SLIBF concept (Solid Lubricant Integrated Base Fluid) was developed precisely to meet the high demands of open gear drives.
It provides excellent adhesion, good film formation, less splashing from the gears and reducing leakages from the gear casing. This results in better maintenance practices and increased safety. It also provides good pumpability at lower temperatures and offers low resistance to pumping the lubricant.
 

High-performance fluid grease for long-term lubrication
Klubersynth BEM 44-4600 is based on high-viscosity PAO oil and a special lithium soap, which prevents components from leaking due to its thixotropic behavior. Compared to other fluid greases it provides a very good thermal stability due to its synthetic composition thus ensures a longer service life of the lubricant and protects against early wear of the components. It offers good compatibility with other fluid greases based on mineral oil and PAO, thus it helps in a smooth change- over to BEM 44-4600.

Operational lubricant for large girth gear drives
Kluberfluid C-F 3 Ultra is a lubricant of a new generation, developed specifically for the lubrication of medium-size to large girth gear drives. It is based on synthetic hydrocarbons and mineral oil. It provides good adhesion, excellent resistance to high pressure and protection against wear. This product is suitable for use at component temperatures up to 120°C.
Kluberfluid C-F 3 Ultra meets the requirements of ANSI/AGMA 9005-E02 annex D-2.