Altemp Q NB 50

Heavy-duty grease for highly-loaded rolling bearings operating at low speeds
Kluberlub BE 41-1501 is designed to meet the requirements of rolling bearings subject to extreme conditions.
FAG FE 8 tests have confirmed the effectiveness of Kluberlub BE 41-1501 under these conditions and it is approved by various bearing manufacturers, e.g. FAG, to be used for applications in low-speed rolling bearings subject to very high loads and shocks, for example in roller presses and bowl mill crushers.

Operational open gear lubricant for large girth gear drives
Kluberfluid C-PG 17 Ultra is based on an innovative synthetic base oil and was developed to meet your increasing demands of modern day open gears.
The high viscosity index of Kluberfluid C-PG 17 Ultra provides the highest film thicknesses and thus the highest load carrying capacity, even if your gears are running at elevated temperatures.
It exceeds the requirements of ANSI/AGMA 6014-B15 Annex D and FLSmidth Minerals Gear Set Lubrication Guidelines.

Graphite based operational lubricant for open gear drives
Because of its unique chemical composition based on an aluminium soap thickener, the GRAFLOSCON C-SG 0 ULTRA provide good adhesion that protects the tooth flank even at extreme loads.The life of the gear is enhanced by the presence of fine graphite particles that form a protective layer and prevent damage.
The vibrations and temperature difference across the tooth flank are reduced. The gears are also protected against corrosion due to the special additives.

Operational lubricant for large girth gear drives
Kluberfluid C-F 8 ULTRA is a newly developed lubricant especially for use on medium-size to large girth gear drives. It is based on a mixture of synthetic hydrocarbons and mineral oil.
Kluberfluid C-F 8 ULTRA provides extremely good adhesion, resistance to high pressure and exceptional wear protection. It is suitable for use at component temperatures up to 120°C.
Kluberfluid C-F 8 ULTRA corresponds to ANSI/AGMA 9005-E02 annex D.

High-temperature screw paste
Kluberpaste HEL 46-450 is a black hot screw paste for high-alloy steels. It contains fully synthetic polyalkylene glycol and ester base oils and a combination of inorganic solid lubricants.
Kluberpaste HEL 46-450 is suitable for a temperature range between -40°C and 1000°C. In the normal temperature range (i.e. below 200°C) it shows good anticorrosion behaviour and good water resistance. Above 200°C it acts as a dry lubricant.

Operational lubricant for open drives
Grafloscon C-SG 2000 Ultra is a sprayable adhesive lubricant with a mineral base oil. It contains aluminium complex soap and solid lubricant particles of fine graphite. It is resistant to high pressure and contains antiwear additives, adhesion improvers and corrosion inhibitors. The raw materials used for the manufacture of Grafloscon C-SG 2000 Ultra are free of bitumen, solvents and chlorine.