Kluberpaste UH1 84-201

Multi-purpose lubricant for high-temperature applications
Klubertemp GR AR 555 is a white, homogeneous long-term grease based on a perfluorinated polyether oil (PFPE) and polytetrafluoroethylene (PTFE).
Klubertemp GR AR 555 offers good corrosion protection and high evaporation stability especially for high-temperature applications.

High-temperature screw paste
Kluberpaste HEL 46-450 is a black hot screw paste for high-alloy steels. It contains fully synthetic polyalkylene glycol and ester base oils and a combination of inorganic solid lubricants.
Kluberpaste HEL 46-450 is suitable for a temperature range between -40°C and 1000°C. In the normal temperature range (i.e. below 200°C) it shows good anticorrosion behaviour and good water resistance. Above 200°C it acts as a dry lubricant.

Lubricant for rolling and plain bearings subject to high loads
Kluberplex BEM 41-141 offers good pressure and wear resistance and does not contain any inorganic solid lubricants like MoS2 or graphite.
Due to its good compatibility with commercial sealing materials, the grease can be used for a wide range of applications.

Lubricating greases for extreme requirements
Kluberplex BE 31-102…-222…-502 are lubricating greases based on mineral oil and special calcium soap. They offer high resistance to mechano-dynamical loads and good adhesion properties. Kluberplex BE 31-102…-222…-502 are highly resistant to media, water and water vapour.

High-performance lubricating greases for the long-term lubrication of rolling and plain bearings
STABURAGS N 12 MF is a mineral oil grease for long-term applications, as well as plain and rolling bearings operating at high temperatures and medium speeds. The solid lubricant it contains (MoS2) ensures emer-gency operation at increased tem-peratures or loads.

Water-miscible sliding dispersion for windscreen wipers made of synthetic or natural rubber and other elastomer components
Windscreen wiper blades are subject to extreme and sometimes conflicting requirements. On the one hand wiper blades have to be structurally stable enough to resist mechanical stress during operation, on the other hand they have to have sufficient flexibility to ensure a satisfactory wiping pattern is achieved in contact with the windscreen. Optimum frictional behavior, especially in the dry/wet friction regime, is therefore of vital importance. Kluberplus S 02-004 has been designed especially for optimization of the frictional behavior of wiper blades. A secondary benefit of the lubricant is that assembly of the wiper blades is also much easier. This also applies to the assembly of other components, such as O-rings etc.. Once applied, Kluberplus S 02-004 forms a dry, flexible, sliding film which ensures prevention of stick slip sliding with minimal lubricant transfer to the mating surface, e.g. the windscreen.