Klubersynth CH 2-100 N

High-temperature lubricating grease for low-noise rolling bearings
ASONIC HQ 72-102 is a synthetic high-temperature lubricating grease. Due to the careful selection of product components and the clean manufacturing environment, ASONIC HQ 72-102 is a rolling bearing grease with a particularly low noise level.

Special lubricating greases for elastomers
SYNTHESO GLK 0 and GLK 1 are special lubricating greases for a wide variety of applications with an almost neutral behaviour towards many elastomers (also EPDM) and plastics. Both products offer excellent wear protection, high load-carrying capacity, good adhesion and resistance to water.

High-temperature lubricating greases
STABUTHERM GH 461 and STABUTHERM GH 462 are high-temperature lubricating greases based on mineral oil and polyurea. They have a wide service temperature range and can be applied in rolling bearings up to 180°C. If the lubricant is used in central lubrication systems, operating temperatures up to 200°C are possible. They have feature highly effective anti-wear properties. The greases are very adhesive and resistant to water both under static and dynamic load. They are resistant to oxidation and provide reliable protection against corrosion.

High-performance lubricating greases for the long-term lubrication of rolling and plain bearings
STABURAGS N 12 MF is a mineral oil grease for long-term applications, as well as plain and rolling bearings operating at high temperatures and medium speeds. The solid lubricant it contains (MoS2) ensures emer-gency operation at increased tem-peratures or loads.

Synthetic air compressor oils for oil change intervals up to 10,000 operating hours
Kluber Summit SH oils are air compressor oils based on synthetic hydrocarbon and additives. They can be mixed with mineral oils and synthetic hydrocarbon oils, however are not miscible with polyglycol oils.

Water-miscible sliding dispersion for windscreen wipers made of synthetic or natural rubber and other elastomer components
Windscreen wiper blades are subject to extreme and sometimes conflicting requirements. On the one hand wiper blades have to be structurally stable enough to resist mechanical stress during operation, on the other hand they have to have sufficient flexibility to ensure a satisfactory wiping pattern is achieved in contact with the windscreen. Optimum frictional behavior, especially in the dry/wet friction regime, is therefore of vital importance. Kluberplus S 02-004 has been designed especially for optimization of the frictional behavior of wiper blades. A secondary benefit of the lubricant is that assembly of the wiper blades is also much easier. This also applies to the assembly of other components, such as O-rings etc.. Once applied, Kluberplus S 02-004 forms a dry, flexible, sliding film which ensures prevention of stick slip sliding with minimal lubricant transfer to the mating surface, e.g. the windscreen.