Altemp Q NB 50

Heavy-duty grease for highly-loaded rolling bearings operating at low speeds
Kluberlub BE 41-1501 is designed to meet the requirements of rolling bearings subject to extreme conditions.
FAG FE 8 tests have confirmed the effectiveness of Kluberlub BE 41-1501 under these conditions and it is approved by various bearing manufacturers, e.g. FAG, to be used for applications in low-speed rolling bearings subject to very high loads and shocks, for example in roller presses and bowl mill crushers.

High-temperature screw paste
Kluberpaste HEL 46-450 is a black hot screw paste for high-alloy steels. It contains fully synthetic polyalkylene glycol and ester base oils and a combination of inorganic solid lubricants.
Kluberpaste HEL 46-450 is suitable for a temperature range between -40°C and 1000°C. In the normal temperature range (i.e. below 200°C) it shows good anticorrosion behaviour and good water resistance. Above 200°C it acts as a dry lubricant.

Light-coloured running-in and correction lubricant for open gear rim/pinion drives
Kluberfluid B-F 2 Ultra is a mineral-oil-based running-in and correction lubricant especially developed for immersion, circulation or spray lubrication.
It contains special additives and surface-smoothing solid particles enhancing the running-in process, i.e. physical/mechanical material removal on new tooth flanks.
Kluberfluid B-F 2 Ultra is a fluid grease that is free of bitumen and raw materials containing solvents, heavy metals or chlorine.

Synthetic air compressor oils for oil change intervals up to 10,000 operating hours
Kluber Summit SH oils are air compressor oils based on synthetic hydrocarbon and additives. They can be mixed with mineral oils and synthetic hydrocarbon oils, however are not miscible with polyglycol oils.

Operational lubricant for open drives
Grafloscon C-SG 2000 Ultra is a sprayable adhesive lubricant with a mineral base oil. It contains aluminium complex soap and solid lubricant particles of fine graphite. It is resistant to high pressure and contains antiwear additives, adhesion improvers and corrosion inhibitors. The raw materials used for the manufacture of Grafloscon C-SG 2000 Ultra are free of bitumen, solvents and chlorine.

Graphite based operational lubricant for open gear drives
Because of its unique chemical composition based on an aluminium soap thickener, the GRAFLOSCON C-SG 0 ULTRA provide good adhesion that protects the tooth flank even at extreme loads.The life of the gear is enhanced by the presence of fine graphite particles that form a protective layer and prevent damage.
The vibrations and temperature difference across the tooth flank are reduced. The gears are also protected against corrosion due to the special additives.