Klubersynth UH1 14-1600

Synthetic gear and multipurpose oil for the food-processing and pharmaceutical industries
Kluberoil 4 UH1 N is a synthetic high-performance gear and multipurpose oil based on PAO satisfying the growing requirements and increasing power density of modern gears.
These are NSF H1 registered and therefore comply with FDA 21 CFR § 178.3570. The lubricants were developed for incidental contact with products and packaging materials in the food-processing, cosmetics, pharmaceutical or animal feed industries.

High-performance fluid grease for long-term lubrication
Klubersynth BEM 44-4600 is based on high-viscosity PAO oil and a special lithium soap, which prevents components from leaking due to its thixotropic behavior. Compared to other fluid greases it provides a very good thermal stability due to its synthetic composition thus ensures a longer service life of the lubricant and protects against early wear of the components. It offers good compatibility with other fluid greases based on mineral oil and PAO, thus it helps in a smooth change- over to BEM 44-4600.

Synthetic long-term grease for rolling and plain bearings, linear motion guides
ISOFLEX TOPAS NCA 52 is a synthetic long-term grease with good low-temperature properties. It has a good load-carrying capacity and ensures smooth running even at high speeds and accelerations.
The thickener made of special calcium soap ensures good adhesion to the component and good resistance to media.
The additives contained in ISOFLEX TOPAS NCA 52 increase wear protection.

Fluid multipurpose grease for long-term lubrication
CENTOPLEX GLP 500 is a fluid multipurpose grease for the long- term lubrication at normal temperatures and high loads.

Universal high-performance lubricant
MICROLUBE GB 0 is a special mineral oil based lubricant. It has a high pressure absorption capacity, provides excellent protection against wear and corrosion, and shows a good wetting behaviour and water resistance.

Lubricating oils for slideways and guideways
LAMORA D oils offer excellent lubricity also at low sliding speeds, enabling constant and precise feed motion of workpiece and tool slides. They ensure good wetting of the sliding surfaces and a high load-carrying capacity, especially of slideways with plastic coatings. Tests at SKC Schmidt GmbH & Co. (formerly Hans Schmidt Gleittechnik GmbH & Co.) have shown that the oils attain "good" to "very good" results both in terms of their coefficients of adhesion and their demulsifying behaviour in contact with customary cooling lubricants.
LAMORA D oils are in compliance with ISO 6743 part 13 GA and GB.