Universal high-performance lubricant
MICROLUBE GB 0 is a special mineral oil based lubricant. It has a high pressure absorption capacity, provides excellent protection against wear and corrosion, and shows a good wetting behaviour and water resistance.
Fluid multipurpose grease for long-term lubrication
CENTOPLEX GLP 500 is a fluid multipurpose grease for the long- term lubrication at normal temperatures and high loads.
Synthetic long-term grease for rolling and plain bearings, linear motion guides
ISOFLEX TOPAS NCA 52 is a synthetic long-term grease with good low-temperature properties. It has a good load-carrying capacity and ensures smooth running even at high speeds and accelerations.
The thickener made of special calcium soap ensures good adhesion to the component and good resistance to media.
The additives contained in ISOFLEX TOPAS NCA 52 increase wear protection.
Synthetic gear and multipurpose oil for the food-processing and pharmaceutical industries
Kluberoil 4 UH1 N is a synthetic high-performance gear and multipurpose oil based on PAO satisfying the growing requirements and increasing power density of modern gears.
These are NSF H1 registered and therefore comply with FDA 21 CFR § 178.3570. The lubricants were developed for incidental contact with products and packaging materials in the food-processing, cosmetics, pharmaceutical or animal feed industries.
Fluid gear grease
MICROLUBE GB 00 is a special mineral oil based grease free from solid lubricants. It has a high pressure absorption capacity, provides excellent protection against wear and corrosion, shows good wetting behaviour, water resistance and backflow behaviour.
Low-temperature greases for slides and small gears
Kluberlub LM 41-32 N and Kluberlub LM 41-102 are special greases based on mineral oil and a lithium soap thickener. Due to their low base oil viscosity Kluberlub LM 41-32 N and Kluberlub LM 41-102 are suitable for temperatures down to –40°C.
Lubricating oils for slideways and guideways
LAMORA D oils offer excellent lubricity also at low sliding speeds, enabling constant and precise feed motion of workpiece and tool slides. They ensure good wetting of the sliding surfaces and a high load-carrying capacity, especially of slideways with plastic coatings. Tests at SKC Schmidt GmbH & Co. (formerly Hans Schmidt Gleittechnik GmbH & Co.) have shown that the oils attain "good" to "very good" results both in terms of their coefficients of adhesion and their demulsifying behaviour in contact with customary cooling lubricants.
LAMORA D oils are in compliance with ISO 6743 part 13 GA and GB.
