Grafloscon C-SG 2000 Ultra

Open Gear Lubricants
Kluberlub OG 11 BH Series are Open Gear Lubricants based on mineral oil, Aluminum Complex Soap thickener and MX technology based on Organo Molybdenum Complex.  
The high viscosity base fluids used in the lubricants provide extreme pressure (EP) and antiwear characteristics to the lubricant.

Synthetic air compressor oils for oil change intervals up to 8,000 operating hours
Kluber Summit SB oils are air compressor oils based on synthetic hydrocarbons and additives. These oils are miscible with mineral oils and synthetic hydrocarbon oils, but not with oils based on polyglycol.
Kluber Summit SB oils offer excellent oxidation and ageing stability and show a good viscosity-temperature behaviour.

Operational lubricant for large gear drives
Klubersynth OA 98-15000 is based on the SLIBF concept (Solid Lubricant Integrated Base Fluid) was developed precisely to meet the high demands of open gear drives.
It provides excellent adhesion, good film formation, less splashing from the gears and reducing leakages from the gear casing. This results in better maintenance practices and increased safety. It also provides good pumpability at lower temperatures and offers low resistance to pumping the lubricant.

Synthetic air compressor oils for oil change intervals up to 10,000 operating hours
Kluber Summit SH oils are air compressor oils based on synthetic hydrocarbon and additives. They can be mixed with mineral oils and synthetic hydrocarbon oils, however are not miscible with polyglycol oils.

Repair lubricant for open girth gear drives
Klüberfluid D-F 1 ULTRA is a running-in and repair lubricant suitable for manual spray application. It is based on mineral oil thickened with lithium soap and contains special additives.

Operational lubricant for large girth gear drives
Kluberfluid C-F 8 ULTRA is a newly developed lubricant especially for use on medium-size to large girth gear drives. It is based on a mixture of synthetic hydrocarbons and mineral oil.
Kluberfluid C-F 8 ULTRA provides extremely good adhesion, resistance to high pressure and exceptional wear protection. It is suitable for use at component temperatures up to 120°C.
Kluberfluid C-F 8 ULTRA corresponds to ANSI/AGMA 9005-E02 annex D.