Fluid gear grease
MICROLUBE GB 00 is a special mineral oil based grease free from solid lubricants. It has a high pressure absorption capacity, provides excellent protection against wear and corrosion, shows good wetting behaviour, water resistance and backflow behaviour.
Special lubricating grease for rolling and plain bearings
Klüberlub BE 71-501 is a light-coloured lubricating grease which offers good compatibility with nonferrous metals like those used for example as plain bearing material. Due to its special formulation and solid lubricants, wear is low when exposed to rotating and oscillating motion and high impact loads. Klüberlub BE 71-501 is resistant to water and has a good sealing effect. The additives contained in this product enhance its ageing resistance.
Low-temperature greases for slides and small gears
Kluberlub LM 41-32 N and Kluberlub LM 41-102 are special greases based on mineral oil and a lithium soap thickener. Due to their low base oil viscosity Kluberlub LM 41-32 N and Kluberlub LM 41-102 are suitable for temperatures down to –40°C.
Lubricating greases for extreme requirements
Kluberplex BE 31-102…-222…-502 are lubricating greases based on mineral oil and special calcium soap. They offer high resistance to mechano-dynamical loads and good adhesion properties. Kluberplex BE 31-102…-222…-502 are highly resistant to media, water and water vapour.
Premium sliding agent for valves, fittings and installations carrying oxygen under very high partial pressure
Kluberalfa YV 93-1202 is a white sliding agent with a good wetting capacity on the basis of perfluorinated polyether oils and solid lubricants.
It provides an exceptionally high stability to oxygen surges and very good resistance to various chemicals.
It is registered according to NSF H1, complies with FDA 21 CFR § 178.3570 and can be used in the food-processing industry.
Synthetic lubricating grease for the food and pharmaceutical processing industry
Klubersynth UH1 14-1600 is a synthetic high-performance lubricating grease. It is registered as NSF H1 and complies with FDA 21 CFR Sec. 178.3570. It is a contributor towards the supporting of food safety. Its soft consistency, good wear protection and scuffing load stage 11 in the FZG test ensure good lubricant distribution and reduced wear in the gear.
Lubricating oils for slideways and guideways
LAMORA D oils offer excellent lubricity also at low sliding speeds, enabling constant and precise feed motion of workpiece and tool slides. They ensure good wetting of the sliding surfaces and a high load-carrying capacity, especially of slideways with plastic coatings. Tests at SKC Schmidt GmbH & Co. (formerly Hans Schmidt Gleittechnik GmbH & Co.) have shown that the oils attain "good" to "very good" results both in terms of their coefficients of adhesion and their demulsifying behaviour in contact with customary cooling lubricants.
LAMORA D oils are in compliance with ISO 6743 part 13 GA and GB.
