Rolling bearing and high-pressure grease
STABURAGS NBU 8 EP is a lubricating grease based on mineral oil and barium complex soap. It has been used successfully for many years as a long-term grease for bearings subject to high specific loads. Its good wear protection properties are enhanced by the barium complex thickener. STABURAGS NBU 8 EP protects reliably against corrosion and is resistant to water.
Graphite based operational lubricant for open gear drives
Because of its unique chemical composition based on an aluminium soap thickener, the GRAFLOSCON C-SG 0 ULTRA provide good adhesion that protects the tooth flank even at extreme loads.The life of the gear is enhanced by the presence of fine graphite particles that form a protective layer and prevent damage.
The vibrations and temperature difference across the tooth flank are reduced. The gears are also protected against corrosion due to the special additives.
Synthetic air compressor oils for oil change intervals up to 10,000 operating hours
Kluber Summit SH oils are air compressor oils based on synthetic hydrocarbon and additives. They can be mixed with mineral oils and synthetic hydrocarbon oils, however are not miscible with polyglycol oils.
High-temperature lubricating grease for bearings and valves
Kluberlub BVH 71-461 is a special lubricating grease based on mineral oil/synthetic hydrocarbon oil/polyurea. It has a wide service temperature range and is suitable for rolling bearings up to a service temperature of 160°C.
Kluberlub BVH 71-461 ensures excellent wear protection, and its EP additives provide a high pressure absorption capacity.
It is very adhesive and resistant to water under static and dynamic loads.
Kluberlub BVH 71-461 is also particularly resistant to oxidation and ageing and reliably protects against corrosion. It has an especially high sealing effect in coke oven valves.
High-temperature grease for slow-running bearings
Klubersynth BH 72-422 is a synthetic high-temperature grease containing ester as well as perfluorinated polyether (PFPE) oils, and a PTFE thickener.
This grease shows good oil retention at high temperature and is thermally stable, which enables Klubersynth BH 72-422 to extend your relubrication intervals at operating temperatures above 160°C up to 220°C.
Heavy-duty grease for highly-loaded rolling bearings operating at low speeds
Kluberlub BE 41-1501 is designed to meet the requirements of rolling bearings subject to extreme conditions.
FAG FE 8 tests have confirmed the effectiveness of Kluberlub BE 41-1501 under these conditions and it is approved by various bearing manufacturers, e.g. FAG, to be used for applications in low-speed rolling bearings subject to very high loads and shocks, for example in roller presses and bowl mill crushers.
Running-in lubricant for open drives
Grafloscon B-SG 00 Ultra is a sprayable running-in lubricant with a mineral base oil. It contains aluminium stearate as a thickener and solid lubricant particles of fine graphite. The lubricant is free from bitumen, heavy metals, solvents and raw materials containing chlorine.
GRAFLOSCON B-SG 00 ULTRA reduces surface roughness and improves the tooth flank quality which makes it also suitable for corrective lubrication if tooth flanks are damaged.
