Petamo GY 193

High-temperature long-term greases
Klubertemp HM greases are long-term lubricating greases based on perfluoropolyether oil and PTFE which has been specifically designed for high-temperature lubrication. Owing to the base oil viscosity and the high load-carrying capacity, Klubertemp HM greases are particularly suitable for the initial and relubrication of medium-speed rolling bearings subject to high temperatures and loads.

High-temperature lubricating oil
HOTEMP 2000 is an advanced, fully synthetic high-temperature oil for friction points that are normally lubricated manually.
HOTEMP 2000 is resistant to temperatures up to 250°C and does not decompose thermally into hard, lacquer-like residues that may stiffen or seize chain joints.

Air-hardening PTFE bonded coating
FLUOROPAN T 20 Spray is a whitish-transparent, air-hardening bonded coating based on PTFE and an organic binder.
When FLUOROPAN T 20 Spray has been applied and hardened, it offers high wear resistance, a low friction coefficient and no stick slip at low speeds. Its adhesion on iron and non-ferrous metals and solvent-resistant plastics as well as wood is good.

High-temperature grease for slow-running bearings
Klubersynth BH 72-422 is a synthetic high-temperature grease containing ester as well as perfluorinated polyether (PFPE) oils, and a PTFE thickener.
This grease shows good oil retention at high temperature and is thermally stable, which enables Klubersynth BH 72-422 to extend your relubrication intervals at operating temperatures above 160°C up to 220°C.

High-temperature lubricating paste
Wolfracoat C is a grey high-temperature lubricating paste containing metal solid lubricant pigments (e.g. copper, graphite). Wolfracoat C counteracts excessive friction, wear and seizing at lubricating points subject to high loads. Wolfracoat C forms a thermally stable lubricating film. At temperatures above 200°C, the solid lubricants remain in the friction points and protect against tribocorrosion and fretting of e.g. fits up to 1200°C.

High-temperature oil for oil-lubricated stenter chains in the textile industry
Klubersynth CTH 2-260 is a special high-temperature chain oil for reliable lubrication at high operating temperatures and loads. It has low evaporation losses at high temperatures and does not form varnish build-up when used correctly - it is important to keep friction points covered with an oil film at all times. It also regenerates pasty used oil at the friction points to ensure sufficient lubrication. It also offers good creeping ability, ensuring quick lubricant film formation.