Staburags NBU 12 MF

High-temperature screw paste
Kluberpaste HEL 46-450 is a black hot screw paste for high-alloy steels. It contains fully synthetic polyalkylene glycol and ester base oils and a combination of inorganic solid lubricants.
Kluberpaste HEL 46-450 is suitable for a temperature range between -40°C and 1000°C. In the normal temperature range (i.e. below 200°C) it shows good anticorrosion behaviour and good water resistance. Above 200°C it acts as a dry lubricant.

High-temperature and long-term grease for rolling bearings
Kluberplex BEM 41-132 is based on synthetic hydrocarbon oil, mineral oil and a special lithium soap. Special additives ensure optimum oxidation resistance as well as protection against wear and corrosion.

Water-miscible sliding dispersion for windscreen wipers made of synthetic or natural rubber and other elastomer components
Windscreen wiper blades are subject to extreme and sometimes conflicting requirements. On the one hand wiper blades have to be structurally stable enough to resist mechanical stress during operation, on the other hand they have to have sufficient flexibility to ensure a satisfactory wiping pattern is achieved in contact with the windscreen. Optimum frictional behavior, especially in the dry/wet friction regime, is therefore of vital importance. Kluberplus S 02-004 has been designed especially for optimization of the frictional behavior of wiper blades. A secondary benefit of the lubricant is that assembly of the wiper blades is also much easier. This also applies to the assembly of other components, such as O-rings etc.. Once applied, Kluberplus S 02-004 forms a dry, flexible, sliding film which ensures prevention of stick slip sliding with minimal lubricant transfer to the mating surface, e.g. the windscreen.

Special lubricating grease for metal pairings in the boundary friction regime
MICROLUBE GNY 202 is a special lubricating grease based on mineral oil. It also contains special sodium soap and the MICROLUBE additive package, which ensures a wear-free surface finish. Running-in wear is reduced to a minimum. In addition, the MICROLUBE additive package provides protection in the boundary friction regime. MICROLUBE GNY 202 shows high resistance to pressure and good anticorrosion properties.

Synthetic air compressor oils for oil change intervals up to 8,000 operating hours
Kluber Summit SB oils are air compressor oils based on synthetic hydrocarbons and additives. These oils are miscible with mineral oils and synthetic hydrocarbon oils, but not with oils based on polyglycol.
Kluber Summit SB oils offer excellent oxidation and ageing stability and show a good viscosity-temperature behaviour.

Special lubricating greases for boundary friction conditions and tribo-corrosion
MICROLUBE GL 261, GL 262 greases are special lubricating greases on a mineral oil base, special lithium soap and the MICROLUBE additive package. Running-in wear is reduced to a minimum. In addition, the MICROLUBE additive package provides protection in the boundary friction regime, thus preventing tribo-corrosion. These greases have the capacity to absorb high pressures, and they have good anti-corrosion properties.