Adhesive lubricant
GRAFLOSCON C-SG 500 PLUS, a sprayable adhesive lubricant based on mineral oil, is aluminium complex saponified and contains solid lubricant (fine graphite). It is resistant to high pressure and is provided with anti-wear additives, adhesion improvers and corrosion inhibitors.
GRAFLOSCON C-SG 500 PLUS is free from bitumen, solvents and lead.
Benefits for your application
Operational lubricant for open drives, sliding and guide rails, rubbing seals
No lead additives
Can be applied through automatic spraying equipment
Repair lubricant for open girth gear drives
Klüberfluid D-F 1 ULTRA is a running-in and repair lubricant suitable for manual spray application. It is based on mineral oil thickened with lithium soap and contains special additives.
Operational lubricant for large girth gear drives
Kluberfluid C-F 8 ULTRA is a newly developed lubricant especially for use on medium-size to large girth gear drives. It is based on a mixture of synthetic hydrocarbons and mineral oil.
Kluberfluid C-F 8 ULTRA provides extremely good adhesion, resistance to high pressure and exceptional wear protection. It is suitable for use at component temperatures up to 120°C.
Kluberfluid C-F 8 ULTRA corresponds to ANSI/AGMA 9005-E02 annex D.
Eco-compatible operating lubricant for open gear drives
Kluberbio LG 39-701 N is a high-performance grease with a new type of base oil and additive package. It combines very good eco-friendliness with high load-carrying capacity, good antiwear and anticorrosive effect and excellent adhesion to surfaces.
The high-viscosity base oil of Kluberbio LG 39-701 N comes from 100 % renewable resources.
Kluberbio LG 39-701 N complies with the 2013 Vessel General Permit requirements of the Environmental Protection Agency (EPA) in terms of biodegradability, minimal toxicity and bio-accumulation to be met by Environmentally Acceptable Lubricants.
Due to the lubricant's excellent low-temperature behaviour, it can be pumped in centralised lubricating systems down to -30°C and sprayed even below 0°C. These positive product characteristics enable you to use the lubricant over a wider temperature range than is common with mineral-oil-based greases of the same base oil viscosity.
Graphite based operational lubricant for open gear drives
Because of its unique chemical composition based on an aluminium soap thickener, the GRAFLOSCON C-SG 0 ULTRA provide good adhesion that protects the tooth flank even at extreme loads.The life of the gear is enhanced by the presence of fine graphite particles that form a protective layer and prevent damage.
The vibrations and temperature difference across the tooth flank are reduced. The gears are also protected against corrosion due to the special additives.
White operating and priming lubricants
Kluberplex AG 11- 462 offer very good wear and corrosion protective properties contributing to an efficient operation of your highly loaded installations and components.
These adhesive greases have proven effective for many years, providing reliable protection of components also when exposed to salt water or during extended periods of standstill.
Operational lubricant for large girth gear drives
Kluberfluid C-F 3 Ultra is a lubricant of a new generation, developed specifically for the lubrication of medium-size to large girth gear drives. It is based on synthetic hydrocarbons and mineral oil. It provides good adhesion, excellent resistance to high pressure and protection against wear. This product is suitable for use at component temperatures up to 120°C.
Kluberfluid C-F 3 Ultra meets the requirements of ANSI/AGMA 9005-E02 annex D-2.
