Kluberfluid B-F 2 Ultra

Operational lubricant for large gear drives
Klubersynth OA 98-15000 is based on the SLIBF concept (Solid Lubricant Integrated Base Fluid) was developed precisely to meet the high demands of open gear drives.
It provides excellent adhesion, good film formation, less splashing from the gears and reducing leakages from the gear casing. This results in better maintenance practices and increased safety. It also provides good pumpability at lower temperatures and offers low resistance to pumping the lubricant.

Graphite based operational lubricant for open gear drives
Because of its unique chemical composition based on an aluminium soap thickener, the GRAFLOSCON C-SG 0 ULTRA provide good adhesion that protects the tooth flank even at extreme loads.The life of the gear is enhanced by the presence of fine graphite particles that form a protective layer and prevent damage.
The vibrations and temperature difference across the tooth flank are reduced. The gears are also protected against corrosion due to the special additives.

Repair lubricant for open girth gear drives
Klüberfluid D-F 1 ULTRA is a running-in and repair lubricant suitable for manual spray application. It is based on mineral oil thickened with lithium soap and contains special additives.

Operational open gear lubricant for large girth gear drives
Kluberfluid C-PG 17 Ultra is based on an innovative synthetic base oil and was developed to meet your increasing demands of modern day pen gears.
The high viscosity index of Kluberfluid C-PG 17 Ultra provides the highest film thicknesses and thus the highest load carrying capacity, even if your gears are running at elevated temperatures.
It exceeds the requirements of ANSI/AGMA 6014-B15 Annex D and FLSmidth Minerals Gear Set Lubrication Guidelines.

Eco-compatible operating lubricant for open gear drives
Kluberbio LG 39-701 N is a high-performance grease with a new type of base oil and additive package. It combines very good eco-friendliness with high load-carrying capacity, good antiwear and anticorrosive effect and excellent adhesion to surfaces.
The high-viscosity base oil of Kluberbio LG 39-701 N comes from 100 % renewable resources.
Kluberbio LG 39-701 N complies with the 2013 Vessel General Permit requirements of the Environmental Protection Agency (EPA) in terms of biodegradability, minimal toxicity and bio-accumulation to be met by Environmentally Acceptable Lubricants.
Due to the lubricant's excellent low-temperature behaviour, it can be pumped in centralised lubricating systems down to -30°C and sprayed even below 0°C. These positive product characteristics enable you to use the lubricant over a wider temperature range than is common with mineral-oil-based greases of the same base oil viscosity.

Open Gear Lubricants
Kluberlub OG 11 BH Series are Open Gear Lubricants based on mineral oil, Aluminum Complex Soap thickener and MX technology based on Organo Molybdenum Complex.  
The high viscosity base fluids used in the lubricants provide extreme pressure (EP) and antiwear characteristics to the lubricant.