Adhesive lubricant
GRAFLOSCON C-SG 500 PLUS, a sprayable adhesive lubricant based on mineral oil, is aluminium complex saponified and contains solid lubricant (fine graphite). It is resistant to high pressure and is provided with anti-wear additives, adhesion improvers and corrosion inhibitors.
GRAFLOSCON C-SG 500 PLUS is free from bitumen, solvents and lead.
Benefits for your application
Operational lubricant for open drives, sliding and guide rails, rubbing seals
No lead additives
Can be applied through automatic spraying equipment
Operational lubricant for large girth gear drives
Kluberfluid C-F 3 Ultra is a lubricant of a new generation, developed specifically for the lubrication of medium-size to large girth gear drives. It is based on synthetic hydrocarbons and mineral oil. It provides good adhesion, excellent resistance to high pressure and protection against wear. This product is suitable for use at component temperatures up to 120°C.
Kluberfluid C-F 3 Ultra meets the requirements of ANSI/AGMA 9005-E02 annex D-2.
Open Gear Lubricants
Kluberlub OG 11 BH Series are Open Gear Lubricants based on mineral oil, Aluminum Complex Soap thickener and MX technology based on Organo Molybdenum Complex.
The high viscosity base fluids used in the lubricants provide extreme pressure (EP) and antiwear characteristics to the lubricant.
Repair lubricant for open girth gear drives
Klüberfluid D-F 1 ULTRA is a running-in and repair lubricant suitable for manual spray application. It is based on mineral oil thickened with lithium soap and contains special additives.
Operational lubricant for large girth gear drives
Kluberfluid C-F 8 ULTRA is a newly developed lubricant especially for use on medium-size to large girth gear drives. It is based on a mixture of synthetic hydrocarbons and mineral oil.
Kluberfluid C-F 8 ULTRA provides extremely good adhesion, resistance to high pressure and exceptional wear protection. It is suitable for use at component temperatures up to 120°C.
Kluberfluid C-F 8 ULTRA corresponds to ANSI/AGMA 9005-E02 annex D.
Eco-compatible operating lubricant for open gear drives
Kluberbio LG 39-701 N is a high-performance grease with a new type of base oil and additive package. It combines very good eco-friendliness with high load-carrying capacity, good antiwear and anticorrosive effect and excellent adhesion to surfaces.
The high-viscosity base oil of Kluberbio LG 39-701 N comes from 100 % renewable resources.
Kluberbio LG 39-701 N complies with the 2013 Vessel General Permit requirements of the Environmental Protection Agency (EPA) in terms of biodegradability, minimal toxicity and bio-accumulation to be met by Environmentally Acceptable Lubricants.
Due to the lubricant's excellent low-temperature behaviour, it can be pumped in centralised lubricating systems down to -30°C and sprayed even below 0°C. These positive product characteristics enable you to use the lubricant over a wider temperature range than is common with mineral-oil-based greases of the same base oil viscosity.
Operational lubricant for large gear drives
Klubersynth OA 98-15000 is based on the SLIBF concept (Solid Lubricant Integrated Base Fluid) was developed precisely to meet the high demands of open gear drives.
It provides excellent adhesion, good film formation, less splashing from the gears and reducing leakages from the gear casing. This results in better maintenance practices and increased safety. It also provides good pumpability at lower temperatures and offers low resistance to pumping the lubricant.
