Kluberfluid C-F 8 Ultra

Operational lubricant for open drives
Grafloscon C-SG 2000 Ultra is a sprayable adhesive lubricant with a mineral base oil. It contains aluminium complex soap and solid lubricant particles of fine graphite. It is resistant to high pressure and contains antiwear additives, adhesion improvers and corrosion inhibitors. The raw materials used for the manufacture of Grafloscon C-SG 2000 Ultra are free of bitumen, solvents and chlorine.

Eco-compatible operating lubricant for open gear drives
Kluberbio LG 39-701 N is a high-performance grease with a new type of base oil and additive package. It combines very good eco-friendliness with high load-carrying capacity, good antiwear and anticorrosive effect and excellent adhesion to surfaces.
The high-viscosity base oil of Kluberbio LG 39-701 N comes from 100 % renewable resources.
Kluberbio LG 39-701 N complies with the 2013 Vessel General Permit requirements of the Environmental Protection Agency (EPA) in terms of biodegradability, minimal toxicity and bio-accumulation to be met by Environmentally Acceptable Lubricants.
Due to the lubricant's excellent low-temperature behaviour, it can be pumped in centralised lubricating systems down to -30°C and sprayed even below 0°C. These positive product characteristics enable you to use the lubricant over a wider temperature range than is common with mineral-oil-based greases of the same base oil viscosity.

Operational open gear lubricant for large girth gear drives
Kluberfluid C-PG 17 Ultra is based on an innovative synthetic base oil and was developed to meet your increasing demands of modern day pen gears.
The high viscosity index of Kluberfluid C-PG 17 Ultra provides the highest film thicknesses and thus the highest load carrying capacity, even if your gears are running at elevated temperatures.
It exceeds the requirements of ANSI/AGMA 6014-B15 Annex D and FLSmidth Minerals Gear Set Lubrication Guidelines.

Running-in lubricant for open drives
Grafloscon B-SG 00 Ultra is a sprayable running-in lubricant with a mineral base oil. It contains aluminium stearate as a thickener and solid lubricant particles of fine graphite. The lubricant is free from bitumen, heavy metals, solvents and raw materials containing chlorine.
GRAFLOSCON B-SG 00 ULTRA reduces surface roughness and improves the tooth flank quality which makes it also suitable for corrective lubrication if tooth flanks are damaged.

Repair lubricant for open girth gear drives
Klüberfluid D-F 1 ULTRA is a running-in and repair lubricant suitable for manual spray application. It is based on mineral oil thickened with lithium soap and contains special additives.